NewProductsPressProfile  • FaqFilesLinksLiteratureSupport Contact
 

About Fred V Fowler

Catalogue Pages

 

 

 

UltraSonic Hardness Tester

Fowler's new Ultrasonic Hardness Tester works on a principle of vibration to measure hardness electrically and through a sophisticated algorithm, converts the measured signal into a accurate, repetitive measurement.
 
UltraSonic Tester Features

Compact size for portable use.
Direct-reading of hardness by digital display.
Very small indentation < 0.001"
Conversion between HV and HRC.
Works with or without standard base.
Multi direction applicability, works in any direction.

Specifications
Indenter Diamond 90 º Indenter for micro-Vickers/conversion to Rockwell C
Test load Approximately 2 Kgf (4.41 lb.f) constant load spring
Measuring ranges Measuring ranges Standard type." HV/HRC
Measuring accuracy HV ±3% of reading. HRC±1.0
Applicable test Primarily steel, other materials using a calibration block.
Measuring displayed Digital (4 figures LED)
Resolution 1 HV / 0.1 HRC
Operating temperature 0-50C (instruments)
Power source AC110/220V(+10%) and NiCad battery (rechargeable)
Display unit size 8 " W x 3" D x 4" H 200 (W) x 68(D) x100 (H).)
Display unit weight 1.54 lbs. (0.7Kg)
Probe weight .77 lbs. (0.35Kg)


If you would like more information or a flyer on our Hardness testers, simply fill out our Information Request Form, or contact our office.

ami