TNC 124

 

For many machining tasks on milling, drilling and boring machines with 3 or 4 axes, a straight cut control with the features offered on the TNC 124 is fully adequate. With the TNC 124, there's no need to write an NC program to perform simple machining tasks. You can move the machine axes either continuously with the axis buttons, in jog increments with an electronic handwheel, or just enter the target position and then start axis motion with a single keystroke.

TNC 124:

 

	Program memory for 20 part programs with up to 2000 program blocks
	Tool offsets for the radius and length of up to 99 tools.
	Fixed cycles with graphical support for bolt hole circles, linear hole patterns, peck drilling and tapping.
	RS-232-C/V.24 data interface.
	Connection for an electronic handwheel (option).